We are still running at full capacity and fully operational, however there may be some slight delays with deliveries from our suppliers.
Our phone lines are currently closed until further notice
If you have any enquiries or questions, please email us at firstname.lastname@example.org as we are answering these during normal hours.
Our retail shop will still remain closed until further notice.
The DEWALT DCN692N 18V XR 90mm Framing Nailer has two speeds (or power levels) to optimise the nailer for firing all lengths of nails. Its BRUSHLESS motor technology offers the power to fire 90mm ring shank nails into soft wood and 63mm into hard woods.
The nailer has two modes. The sequential operating mode allows for precision placement and the bump operating mode provides the user with production speed.Its mechanical rather than gas operation offers consistant performance and minimises cleaning/service requirements. Tool free stall/jam clearance minimises user down time.
The DCN692 has a versatile 30-34Â° magazine angle that will accept most clipped head and off centre round head paper tape or wire weld collated framing nails. Depths can be easily adjusted using the thumb wheel depth adjuster.
The nailer has excellent vibration and sound figures, which offer fantastic user protection. The tool has an ergonomic design to allow the nailer to fit easily between a 400mm centre stud. A reversable belt/rafter hook povides increased portability and versatility on the job site.
Increased visibility and durability along with protection for work-surface from the non-mar contact trip with lock-off to prevent accidental discharge of the fastener.
Ideal for the following applications:
Stud Wall Installation
Floor Board Installation
Input power: 18 Volt.
Nail Diameter: 2.8-3.3mm.
Nail length: 50-90mm.
Magazine Capacity: up to 55 nails.
Firing mode: Bump and Sequential.